This winch support is specifically designed for vertical pulling with the PCH2000.
Equipped with an adjustable shelf, it offers a solid and stable support allowing to properly sit the winch.
It also features a removable V-shaped pulley mounted on ball bearings, providing optimal rotation. This pulley redirects the rope vertically with an angle in order to reach sections of towers or pylons away from the center. To install the rope, simply remove the "T" handle and the pulley, thread the rope and put the handle and pulley back in position.
Note that this support can also be used for horizontal pulling; in this case, the pulley will not be used.
In all cases, it can not be used alone; it must be combined with other accessories in order to be used. Refer to the chart of anchorages for winches (pdf) at the bottom of this page to visualize the combinations of accessories that can be done with the PCA-2264.
Thus, the PCA-2264 will be combined with the following accessories to perform horizontal pulling. In these cases, the winch will face the load and the rope will be in a direct line towards the winch.
| Fig. 5
|| PCA-1263 + PCA-1332 + PCA-2264
| Fig. 11
|| PCA-1267 / PCA-1501 + PCA-1332 + PCA-2264
|Fig. 16|| PCA-1266 + PCA-1332 + PCA-2264
|Fig. 21|| PCA-1806 + PCA-1332 + PCA-2264
If combined with the following accessories, it will be used for vertical pulling. In these cases, the winch will face the anchor point and the rope will come from the top to the winch.
| Fig. 7
|| PCA-1263 + PCA-2264
| Fig. 13
|| PCA-1267 / PCA-1501 + PCA-2264
| Fig. 18
|| PCA-1266 + PCA-2264
|Fig. 23||PCA-1806 + PCA-2264|
FOR WINCH PCH2000 ONLY