The pylon mount anchor system is designed to fit different winch models directly to the main frame of a 90° V-shaped pylon. It is the basis of different combinations of accessories. It is easily installed by one person thanks to the integrated magnets at the back of the support that keep it in place during the installation. Four reversible aluminum anchor hooks, with slots of three (3) different widths, hold onto most 10 cm to 30 cm steel angles - single or double thickness. These hooks are tight in place by hand. Thanks to the four-star handles, no tools are needed for installation.
It can not be used alone; it must be combined with different accessories to use it. Refer to the chart of anchorages for winches (pdf) at the bottom of this page to visualize the combinations of accessories that can be done with the PCA-1806.
Thus, it will be combined with the following accessories to allow horizontal pulling. In these cases, the winch will face the load and the rope will be in a direct line towards the winch.
|Fig. 20||PCA-1806+ PCA-1332 + PCA-1264|
|Fig. 21||PCA-1806+ PCA-1332 + PCA-2264|
If combined with the following accessories, it will be used for vertical pulling. In these cases, the winch will face the anchor point and the rope will come from the top to the winch.
|Fig. 22||PCA-1806+ PCA-1264|
|Fig. 23||PCA-1806+ PCA-2264|
FOR WINCHES: PCW3000, PCW3000-Li, PCW5000, PCW5000-HS, PCH1000, PCH2000, PCT1800