Specially designed for North American vehicles, this 30.5 cm x 50.8 mm (12" x 2 ") square tube fits snugly on all Category III towing attachments. It allows to firmly install the winch to a vehicle. It also includes a 12 mm (1/2 ") bent pin and an 'R' tie. It is the basis of different combinations of accessories.
It can not be used alone; it must be combined with different accessories to use it. Refer to the chart of anchorages for winches (pdf) at the bottom of this page to visualize the combinations of accessories that can be done with the PCA-1267.
Thus, it will be combined with the following accessories to allow horizontal pulling. In these cases, the winch will face the load and the rope will be in a direct line towards the winch.
|Fig.9||PCA-1267 + PCA-1268|
|Fig. 10||PCA-1267 + PCA-1332 + PCA-1264|
|Fig. 11||PCA-1267 + PCA-1332 + PCA-2264|
If combined with the following accessories, it will be used for vertical pulling. In these cases, the winch will face the anchor point and the rope will come from the top to the winch.
|Fig. 12||PCA-1267 + PCA-1264|
|Fig. 13||PCA-1267 + PCA-2264|
FOR WINCHES: PCW3000, PCW3000-Li, PCW5000, PCW5000-HS, PCH1000, PCH2000, PCT1800